Stack Select - Kyocera FS-9120DN Operating Manual

1 Press the MENU key.
2 Press the or
Handling > appears.
Paper Handling >
3 Press the key.
4 Press the or
Mode appears.
>Duplex Mode
None
5 Press the ENTER key. A blinking question mark (?)
appears.
>Duplex Mode
?None
6 Press the or
mode. The display changes as shown below.
None (default)
Short edge bind
Long edge bind
7 When the desired duplex mode is displayed, press
the ENTER key.
8 Press the MENU key. The message display returns to
Ready.
Selecting the Output Device
You can select whether printouts will be received by the
printer's top tray (face-down) or to the optional document
finisher's output tray.
1 Press the MENU key.
2 Press the or
Handling > appears.
Paper Handling >
3 Press the key.
key repeatedly until Paper
key repeatedly until >Duplex
key to display the desired duplex
key repeatedly until Paper
Chapter 3 Using the Operator Panel
4 Press the or
Select appears.
>Stack Select
Top tray FaceDn
5 Press the ENTER key. A blinking question mark (?)
appears. The selected output device will be displayed.
>Stack Select
?Top tray FaceDn
6 Press the or
tion. The output tray changes as shown below.
Top tray FaceDn
Finisher FaceUp (when document finisher is
Finisher FaceDn (when document finisher is
7 When the desired paper source displayed, press the
ENTER key.
8 Press the MENU key. The message display returns
to Ready.
Adjusting the Stitch Positions
When installing the option document finisher DF-75, adjust the
stitch positions using the following procedures. In the default
settings, the stitch position is set in the center of the paper. De-
pending on the paper, a certain amount of deviation will occur.
In this case, also use this menu to adjust the stitch position.
The adjustment can be done by moving the stitch position
adjustment gear in the document finisher.
For example, select the range from -57 to +57 (1 = approxi-
mately 0.14 mm) to move the stitch position approximately 8
mm as shown in the following figure. The default setting is
000 (center of the paper.)
Default stitch position
(center of the paper)
Feed direction
(Approx. 8 mm)
Figure 3-21
key repeatedly until >Stack
key to display the desired destina-
equipped)
equipped)
-57 +57
(Approx. 8 mm)
3-45