Kyocera FS-9120DN Operating Manual page 46

3 Press the key to select an internal font, press the
or key repeatedly until Internal appears.
>Font Select
Internal
To select an option font, press the ENTER key while
> Font Select > is displayed. Press the
key repeatedly until the message display indicates
Option.This operation is possible only when option
fonts are installed in the printer.
4 Press the key.
>> I000
The letter before the number indicates the type of
font as follows:
Letter Description
I Internal fonts
S Soft (down load) fonts
M Fonts in an option memory card
H Fonts in a RAM disk or hard disk
O Fonts in an option ROM
Table 3-8
5
Press the ENTER key. A blinking question mark (?)
appears.
>>?I000
6 Press the or key repeatedly until the desired
font number appears. For font numbers of the inter-
nal fonts, see List of Fonts on page 6-1
>Font Select
Internal
7 When the desired font is displayed, press the ENTER
key.
8 Press the MENU key. The message display returns to
Ready.
>
or
.
>
Chapter 3 Using the Operator Panel
Changing Type for Courier/Letter Gothic
Courier or Letter Gothic font type can be selected as Regular or
Dark. For example, to change the type of Courier, proceed as follows:
1 Press the MENU key.
2 Press the or
pears.
Font
3 Press the key.
4 Check that Internal is displayed and press the
key.
>Font Select
Internal
5 Press the or
pears.
>>Courier
Regular
6 Press the ENTER key. A blinking question mark (?)
appears.
>>Courier
? Regular
7 Select Regular or Dark using the
8 Press the ENTER key.
9
Press the MENU key and the message display re-
turns to Ready.
Changing the Font Size
You can change the size of the default font. If the default font
is a fixed-pitch font such as Courier or Letter Gothic, the
character pitch can be changed instead of the font size.
1 Press the MENU key.
2 Press the or
pears.
Font
key repeatedly until Font > ap-
>
>
key repeatedly until >Courier ap-
or key.
key repeatedly until Font > ap-
>
3-25