Operating An Option Hard Disk - Kyocera FS-9120DN Operating Manual

Chapter 3 Using the Operator Panel
5 Press the ENTER key. A blinking question mark (?)
appears.
>EcoPrint Mode
? Off
6 Select On or Off using the
7 Press the ENTER key.
8 Press the MENU key. The message display returns to
Ready.
Resolution
You can set the default print resolution in three ways:
300 dpi, 600 dpi and Fast 1200 mode. The clarity of printed
characters and graphics becomes sharper in this order. (The
factory setting is Fast 1200 mode.)
1 Press the MENU key.
2 Press the or
Quality > appears.
Print Quality
3 Press the key.
4 Press the
>Resolution appears.
>Resolution
Fast 1200 mode
5 Press the ENTER key. A blinking question mark (?)
appears.
>Resolution
? Fast 1200 mode
6 Select Fast 1200 mode or 300 dpi, 600 dpi using the
or key.
7 Press the ENTER key.
8 Press the MENU key. The message display returns to
Ready.
3-32
or key.
key repeatedly until Print
>
or key repeatedly
Adjusting the Print Density
The print density can be adjusted in five steps: from 01 (light)
to 05 (dark). The factory setting is 03.
1 Press the MENU key.
2 Press the
Quality > appears.
Print Quality
3 Press the
4 Press the
Density appears.
>Print Density
03
5 Press the ENTER key. A blinking question mark (?)
appears.
>Print Density
? 03
6 Select the print density from five steps from 01
(light) to 05 (dark) using the
7 Press the ENTER key.
until
8 Press the MENU key. The message display returns to
Ready.

2.2.9 Operating an Option Hard Disk

By installing the option hard disk into the printer, the e-MPS
function can be used. The printer's menu selection system al-
lows you to perform the following operations on the hard disk.
If the option hard disk is not formatted, the >Format menu
will automatically appear on the message display.
• Reading data
• Writing data
• Deleting data
• Printing of list of partitions
Reading Data
Data stored on a hard disk can be read. To read data on a hard
disk, proceed as follows.
1 Press the MENU key.
or key repeatedly until Print
>
key.
or key repeatedly until >Print
or key.