Operating The Storage Device - Kyocera FS-2000D Advanced Operation Manual

Using the Operation Panel

Operating the Storage Device

Using the CompactFlash Card
2-54
The printer supports four types of storage device; CompactFlash card,
Microdrive, USB flash memory, and RAM disk. The CompactFlash card
and Microdrive are installed into the dedicated slots of the printer. The
RAM disk is an allocated part of the printer's memory. If the Microdrive is
installed in the printer, the e-MPS function will be available. For details,
refer to e-MPS on page 2-19.
The basic operations of each storage device are the same. This section
explains the operation of the CompactFlash card.
The printer is equipped with a slot for a CompactFlash card. By inserting a
CompactFlash card into the printer, the following operations become
available.
• Reading Font Data
• Reading Data
• Writing Data
• Deleting Data
• Formatting CompactFlash Card
• Printing a List of Data Names
For details about the handling of the memory card, refer to Microdrive
(Hard Disk)/CompactFlash (Memory) Card on page 3-6.
Reading Font Data
If a CompactFlash card with the font data is inserted into the slot when the
printer is turned on, the fonts are automatically read into the printer.
1 Press [Menu].
Press ? or @ repeatedly until Memory
2
Card > appears.
Press B.
3
Press ? or @ repeatedly until >Read
4
Fonts appears.
5
Press [OK]. A question mark (?) appears.
Memory Card
>Read Fonts
>Read Fonts ?
ADVANCED OPERATION GUIDE
>