Kyocera FS-2000D Advanced Operation Manual page 47

Using Proof-and-Hold
ADVANCED OPERATION GUIDE
5 Press [OK]. A blinking question mark (?)
appears before the user name.
Press ? or @ to display the desired user
6
name, Arlen, in this example.
7 Press [OK]. The job name entered in the
printer driver (Report, in this example)
appear with a blinking question mark (?)
before the letters.
Press ? or @ to scroll to the desired job title.
8
9 Press [OK]. The number of copies to be
printed can be set. To increase the copy
count, press ?; to decrease the copy count,
press @.
10
Press [OK] to finalize the copy count. The printer prints the specified
number of copies for the job.
Deleting a Quick Copy Job
1 Follow steps 1 through 8 in the above section to let the title of the job to be
deleted displayed.
2
When the title of the job to be deleted is
displayed, e.g. Report, press [OK]. The
cursor below the copy count starts to blink.
Press @ repeatedly until Delete appears
3
below the title.
4
Press [OK]. The stored quick copy job is deleted.
When you print multiple copies, this mode first prints one copy so that you
can proof it before continuing to print the remaining copies. Since you can
proof the printouts before printing the remaining copies, wastage of paper
can be reduced.
The printer prints one copy and, at the same time, saves the print job on
the Microdrive/RAM disk. You can also change the number of copies when
resuming printing from the operation panel.
When the printer is turned off, all stored jobs will be deleted.
Using the Operation Panel
>Quick Copy
?Harold
>Quick Copy
?Arlen
>Arlen
?Report
>Report
Copies 001
>Report
Copies 001
>Report
Delete
2-21