Kyocera FS-2000D Advanced Operation Manual page 111

Setting the Error Clear Time
ADVANCED OPERATION GUIDE
Press ? or @ repeatedly until Others >
2
appears.
Press B.
3
Press ? or @ repeatedly until >Auto
4
Error Clear > appears.
5 Press [OK]. A blinking question mark (?)
appears.
Select On or Off using ? or @.
6
7 Press [OK].
8
To exit the menu selection, press [Menu]. The display returns to Ready.
1
Press [Menu].
Press ? or @ repeatedly until Others >
2
appears.
Press B.
3
Press ? or @ repeatedly until >Auto
4
Error Clear > appears.
Press B and display >>Error Clear
5
Timer. The default setting is 30 seconds.
6
Press [OK]. A blinking cursor (_) appears.
Press ? or @ to increase or decrease the value at the blinking cursor and
7
set the desired time. The time must be set between 000 and 495 seconds,
in 5-second increments. If set to 000, printing will be continued
Using the Operation Panel
Others
>Auto Error
Clear Off
>Auto Error
Clear ? Off
Others
>Auto Error
Clear On
>>Error Clear
Timer 030sec.
>>Error Clear
Timer 030sec.
2-85
>
>
>
>