Charging The Actiwave From The Pc - CamNtech The Actiwave User Manual

3.3 Charging the
Actiwave
from the PC
Approximate
Voltage
indicated by
charge gauge
3.90V
3.55V
Actiwave User Guide - Issue 2.0.18
There are two modes of operation when the dock is
connected to the PC (and the PC is switched on):
1. Stand-alone mode:
running; the Actiwave devices are charged and their
charge status is indicated by the LEDs on the dock. While
the Actiwave is charging, the LED will be RED. When the
Actiwave is charged, the LED will stay GREEN. Note that
the status will alternate between charged/charging as the
charge level rises, and occasionally show red in order to
maintain full battery charge.
2. Managed Mode:
running on the PC. The main display will show a bar graph
of the approximate battery level on the respective channel.
CHARGED
An Actiwave which has been used should be left charging
on the reader for a period of several hours, if you require it
fully charged. The estimated battery level shown may not
be fully accurate during charging itself, so it is advisable to
leave the unit connected and charging for some time if the
indication has reached green after only a short period.
The Actiwave software is not
In this mode, the Actiwave software is
CHARGING
CHARGED
Page 15