Table of Contents
Advertisement
2.3
Updating the
software.
2.4
Installing the
USB drivers
for the
Interface
Dock
Actiwave User Guide - Issue 2.0.18
software on a remote server is not guaranteed as network
settings vary considerably.
The software should not be started until you have
connected the reader and installed the drivers required by
the USB reader charger (see Section 2.4).
Please note the copyright warning. By accepting this, the
user is accepting the CamNtech terms and conditions of
use of the Actiwave software
If you are updating or reinstalling the software you should
remove the old version first when prompted by the
installation wizard.
restarted by removing and re-inserting the CD ROM or by
double-clicking on the Actiwave.msi file.
This section on installing drivers only applies to new
installations.
Insert the supplied CD ROM into the CD/DVD drive on
the host PC and plug the Actiwave reader/charger into a
free USB Port.
The installation menu will automatically be displayed
(see Section 2.2).
Depending upon the operating system and current
driver status, the computer may display a message saying
'Found New Hardware' and should then load the drivers
with no user intervention. The installation menu can be
cancelled in this case.
If the drivers do not load automatically, or if you wish to
make sure they install correctly, you may choose 'Install
CamNtech USB Drivers' from the installation menu and
then carefully follow the instructions on-screen.
If you have difficulty, consult the procedure; 'Installing
USB Drivers Manually', which is included in Appendix 2 of
this manual.
A screen may appear that tells the user that the driver
is not digitally signed by Microsoft:
Select 'Continue Anyway' (Please note that this is NOT
a problem and just means that the Actiwave version of the
driver software has not been assessed by Microsoft. In
fact the actual drivers are Microsoft approved).
The installation has to then be
Page 12
Advertisement
Table of Contents
