Installation Steps; Installing The Optional Batteries; Setting The Dialing Mode - ClearSounds CSC50 Installation Manual & User Manual

Installation of your ClearSounds™ CSC50 Amplified Phone is easy. There are some basic
steps you need to take when you set-up your CSC50 Phone for the first time.
1. Check parts list.
2. Install (4) AAA Alkaline batteries (not included). This provides power to the Caller ID
Screen.
3. Set the dialing mode.
4. Choose desktop or wall mount.
5. Set ringer and auxiliary alert.
6. Program your memory dial buttons.

INSTALLING THE OPTIONAL BATTERIES

The batteries are necessary in case of network power failure to save stored numbers in
memory and are required for the "Phone Book" use.
1. Open the battery compartment door located on the bottom of your phone by un-
screwing the battery compartment door and removing it from the bottom of your
phone (screwdriver provided).
2. Insert correctly 4 AAA alkaline batteries (purchased separately) in the battery com-
partment
(See figure #6)
of the compartment.
3. Replace the battery compartment door and screw back in place.
4. The batteries will last approximately 1 year before needing replacement.
NOTE: Always unplug the line cord before installing new batteries.

SETTING THE DIALING MODE

Set the dial mode switch on the bottom of the phone to "T" if you have Touch Tone service,
or "P" for Pulse dialing if you have rotary dialing service. Default is set to the "T" dialing
switch mode
(See figure #7)

Installation Steps

(See page #5 for complete list)
. Be sure to observe battery polarity as imprinted on the base
Figure #6 – Installing the batteries
.
Figure #7 – Dialing mode switch
11