Using The Volume Reset Override; Using The Outgoing Speech Volume - ClearSounds CSC50 Installation Manual & User Manual

the phone and alert other users that hearing damage can potentially result from misuse.

Using the volume reset override

In standard mode, the phone will reset to normal sound levels when you hang up. This
allows people who do not require the level of amplification offered on the phone to use it.
If you would like to override the reset, simply turn the AUTO AMPLIFY switch on the back
of the phone to "ON" using the tip of a pencil or paper clip
(See figure #28).
IMPORTANT: When the AUTO AMPLIFY switch is in the "ON" position, you do not need
to press the "AMPLI" (amplify) button. Your amplification setting will remain as set.
On any call, you can temporarily turn OFF and turn back ON the AUTO AMPLIFY feature
by pressing the "AMPLI" button.
Figure #28 – Volume Reset Override Switch
Using your CSC50 Amplified Phone with hearing aids
Your CSC50 Phone can be used with hearing aids equipped with a telecoil (T-coil). Adjust
your hearing aid "T-switch" to the "T" position. Make sure to hold the handset close to your
hearing aid.

Using the Outgoing Speech Volume

You can adjust the sending volume (outgoing volume up to 12 dB of gain) by using the
Speech Volume Control located on the right side of your CSC50 Phone. If your voice is
faint or weak, adjust the volume to "HI". You can also decrease the volume as well. There
are three levels available "LO, NORMAL & HI" .
(See figure #29)
Figure #29 - Outgoing Speech Volume Switch
21