Setting The Dialing Mode - ClearSounds CL600 Installation Manual & User Manual

5. Holding the phone slightly above the mounting screws on the wall jack, push the
phone against the mounting screws so they are hooked into upper and lower key-
hole slots on the back of the phone. Slowly slide the phone down until it snaps into
place
(See diagram #10)
6. Connect the handset coil cord (curly cord) to the handset and to the telephone.
7. Lift the handset and listen for a dial tone. If you hear a dial tone, your phone is ready
to use. If there is no dial tone, check all your cords to make sure they are plugged in
securely.
DIAGRAM #8 – Reversing The Hook

SETTING THE DIALING MODE

The Tone/Pulse is factory pre-set to Tone (T). Please check with your local telephone
company if uncertain of the type of service. You can review or change the settings as
follows:
In the hook position (handset in cradle),
1. Press the MUTE button to access the special features.
2. Using the
PHONE>>.
3. Press the OK (green) button.
4. Using the
MODE>>.
5. Press OK button.
6. Press the C button 3 times to exit.
12
.
DIAGRAM #10 – Wall Installation
or arrow buttons (below the Caller ID Display), highlight <<SET
or arrow buttons, scroll to select <<TONE MODE OR PUSLE
DIAGRAM #9 – Mounting The Wall Bracket