Auto On Hook; Troubleshooting Guide Pages - ClearSounds CL600 Installation Manual & User Manual

4. Press the C button.
5. The Screen will display "DEL?"
6. Press again the C button to confirm.
7. Press the OK button to exit.

Auto On Hook

Should you leave the CL600 or another telephone off the hook, when the Auto On Hook
feature is ON, your ClearSounds CL600 will automatically hang-up the line after 5 - 8
minutes and your CL600 Phone will ring as you selected so you never miss a call
.
page #20)
No dial tone
1. Check that all phone cord connections (including the curly cord) and AC Adapter are
securely plugged into the telephone & wall jack.
2. Check that the phone is in the correct dialing mode, Touch-Tone / Pulse Setting.
3. Plug another phone into the jack to make sure your phone service is functioning
properly.
Call will not dial or dials very slowly
1. Check that the phone is in the correct dialing mode, Touch-Tone / Pulse Setting
.
page #12)
No audible ringer
1. Make sure the ringer is not set to the "OFF" position
2. Check the volume level of the ringer.
3. You may have too many extensions on your line. Try unplugging a few devices.
Having too many telephones /accessories can also create problems such as low
ringer volume or impaired quality during calls.
No Strobe Ringer and/or bed shaker will not activate
1. Make sure the strobe and/or shaker switch is turned "ON"
2. Make sure the Bed Shaker is plugged in all the way.
3. Make sure the Bed Shaker is plugged into the correct jack
No amplification
1. Check to see if the AMPLI amplify button is "ON"
should be lit.
2. Check the AC Power Adapter and make sure it is plugged into the wall and into the
appropriate jack on the phone.
Noise, Static, Interference while using the handset
1. A filter may be required for homes with DSL line or near Radio towers.
Troubleshooting Guide
(See diagram #11)
(See diagram #15)
(See diagram #14)
. The red light
(See diagram #23)
(See
(See
.
.
.
35