Periodic Maintenance; Maintenance Schedule; Storage - Kohler CV11-16 Service Manual

Periodic Maintenance

WARNING: Accidental Starts!
Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or
equipment, disable the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-)
battery cable from battery.

Maintenance Schedule

These required maintenance procedures should be performed at the frequency stated in the table. They should
also be included as part of any seasonal tune-up.
Frequency
• Fill fuel tank.
Daily or Before
• Check oil level.
Starting Engine
• Check air cleaner for dirty
• Check air intake and cooling areas, clean as necessary
• Service precleaner element
Every 25 Hours
• Replace air cleaner element
Every
• Change oil
100 Hours
• Remove cooling shrouds and clean cooling areas
Every
• Change oil filter
200 Hours
• Check spark plug condition and gap.
Annually or
• Have bendix starter drive serviced
Every
• Have solenoid shift starter disassembled and cleaned
500 Hours
1 Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.
2 Have a Kohler Engine Service Dealer perform this service. Not necessary on Delco Starters.

Storage

If the engine will be out of service for two months or
more, use the following storage procedure.
1. Clean the exterior surfaces of the engine.
2. Change the oil and oil filter while the engine is still
warm from operation. See "Change Oil and Oil
Filter" in Section 6.
3. The fuel system must be completely emptied, or
the gasoline must be treated with a stabilizer to
prevent deterioration. If you choose to use a
stabilizer, follow the manufacturers
recommendations, and add the correct amount
for the capacity of the fuel system. Fill the fuel
tank with clean, fresh gasoline. Run the engine for
2-3 minutes to get stabilized fuel into the
carburetor.
Maintenance Required
1
, loose, or damaged parts.
1 .
1
.
1 .
1
.
2
.
Safety and General Information
1 .
1
.
2
.
To empty the system, run the engine until the tank
and system are empty.
4. Remove the spark plug. Add one tablespoon of
engine oil into the spark plug hole. Install the plug,
but do not connect the plug lead. Crank the
engine two or three revolutions.
5. Remove the spark plug. Cover the spark plug
hole with your thumb, and turn the engine over
until the piston is at the top of its stroke. (Pressure
against thumb is greatest.) Reinstall the plug, but
do not connect the plug lead.
6. Store the engine in a clean, dry place.
Section 1
1
Refer to:
Section 5
Section 6
Section 4
Section 4
Section 4
Section 4
Section 6
Section 4
Section 6
Section 8
Section 8
Section 8
1.5