Table of Contents
Advertisement
5.1 Useful information about maintenance
• This chapter shows all operations described in the Tab. 5.1
and Tab. 5.2 that may be directly carried out by the user.
• Periodic inspection and maintenance operations must
be carried out as indicated in this manual and are the
responsability of the user.
• Failure to comply with these service and maintenance
intervals increases the risk of technical damage to the
engine. Any non compliance makes the warranty become
null and void.
• In order to prevent personal and property damage read
carefully the instructions listed below before proceeding
with any operation of the engine.
5.2 Periodic maintenance
The intervals of preventive maintenance in Tab. 5.1 and Tab. 5.2 refer to the engine operating under normal operating conditions
with fuel and oil meeting the recommended specifications.
5.2
OPERATION DESCRIPTION
Engine oil level
(8)
Coolant level
(8) (9)
Radiator heat-exchange surface
Rubber hose
Fuel hose
Starter Motor
(6)
5.3
OPERATION DESCRIPTION
Engine oil and Oil filter cartridge
Fuel filter cartridge
and prefilter
(1)
Coolant pump belt
(3) (6)
Alternator belt
(3) (6)
Water pump impeller
Dry air cleaner cartridge
(2)
Intake manifold hose (air filter - intake manifold)
Coolant hoses
(6) (7)
Fuel hoses
(6) (7)
Coolant
(6)
1. In case of low use: 12 months.
2. The period of time that must elapse before checking
the filter element depends on the environment in which
the engine operates. The air filter must be cleaned and
replaced more frequently under very dusty conditions.
3. In case of low use: 36 months.
6. Contact authorized Lombardini Marine workshops.
ED0053030870
_04
INFORMATION ABOUT MAINTENANCE
CLEANING AND CHECKING
(2) (8)
CLEANING AND CHECKING
(1)
(12)
(6) (7)
Warning
• Inspections must be made when the engine is off and cold.
• Place engine on level surface to ensure accurate
measurement of oil level.
• Before starting, to avoid spillages of oil make sure that:
- the oil dipstick is inserted correctly;
- also check that:
- oil drain plug and
- oil filler cap are tightened firmly.
Important
• Before proceeding with operation, read
PERIOD (HOURS)
100
250
PERIOD (HOURS)
100
250
7. The replacement interval is only an indication, it strongly
depends from environmental condition and hose status
detected during regular visual inspection.
8. The first check must be done after 10 hours.
9. Test the coolant condition annually with coolant test strips.
12. Not supplied by Lombardini Marine.
5
Par. 3.2.2.
PAR.
500
5000
5.3
5.5
5.6
5.4
5.4
--
PAR.
500
6.1/6.2
6.3
6.7
6.6
6.4
6.8
--
--
--
6.5
23
EN
Advertisement
Table of Contents
