Information About Maintenance; Useful Information About Maintenance; Periodic Maintenance - Kohler KDI 2504 TCR MGWI Owner's Manual

5.1 Useful information about maintenance

• This chapter shows all operations described in the Tab.
5.1 and Tab. 5.2 if you have the skills appropriate may be
directly carried out by the user.
• Periodic inspection and maintenance operations must
be carried out as indicated in this manual and are the
responsability of the user.
• Failure to comply with these service and maintenance
intervals increases the risk of technical damage to the
engine. Any non compliance makes the warranty become
null and void.
• In order to prevent personal and property damage read
carefully the instructions listed below before proceeding
with any operation of the engine.

5.2 Periodic maintenance

The intervals of preventive maintenance in Tab. 5.1 and Tab. 5.2 refer to the engine operating under normal operating conditions
with fuel and oil meeting the recommended specifications.
5.1
OPERATION DESCRIPTION
Engine oil level
(8) (4)
Coolant level
(8) (4)
Checking the zinc anode
Radiator heat-exchange surface and Intercooler
Alternator belt tension
Rubber hose (intake air / coolant)
Fuel hose
(7)
Starter Motor
(6)
Alternator
(6)
5.2
OPERATION DESCRIPTION
Engine oil
(1)
Oil filter cartridge
(1)
Fuel filter cartridge
(1)
Coolant
(4) (6)
Alternator belt
(3)
Water pump impeller
Intake manifold hose (air filter - intake manifold)
Coolant hoses
(6) (7)
Fuel line hose
(6) (7)
1. In case of low use: 12 months.
2. The period of time that must elapse before checking
depends on the environment in which the engine operates.
Cleaned and replace more frequently under very dusty
conditions.
3. In case of low use: 36 months.
4. In case of low use: 24 months.

INFORMATION ABOUT MAINTENANCE

CLEANING AND CHECKING
(8) (4)
(6)
(5) (8)
(7)
(4)
(6) (7)
• Before proceeding with operation, read
• Inspections must be made when the engine is off and cold.
• Place engine on level surface to ensure accurate
measurement of oil level.
• Before starting, to avoid spillages of oil make sure that:
- the oil dipstick is inserted correctly;
- also check that:
oil drain plug and; oil filler cap are tightened firmly.
PERIOD (HOURS)
100 250
Refer to the technical documentation of the machine.
REPLACEMENT
PERIOD (HOURS)
250 500
Refer to the technical documentation of the machine.
5. Not Poly-V type.
6. The operation must be carried out by authorized
KOHLER workshops or skilled personnel.
7. The replacement interval is only an indication, it strongly
depends from environmental condition and hose status
detected during regular visual inspection.
8. The first check must be done after 10 hours.
5
Important
Par. 3.2.2.
Warning
PAR.
500 5000
5.3
5.6
5.7
5.6
5.5
5.5
--
--
PAR.
1000 5000
6.1
6.2
6.3
6.5
6.6
--
--
--
EN
25