Diagnostic And Repair Tools; Section 2 Special Tools - Kohler CV11-16 Service Manual

Section 2
Special Tools

Diagnostic and Repair Tools

The tools listed in the following table are used for specific diagnosis or repair procedures, as described. Order
from SPX Corp.
Description
Hydraulic Lifter Tool
Designed to remove and install hydraulic lifters
Ignition Tester
Used for testing output on capacitive discharge (CD) ignition systems
Ignition Tester
Used for testing ouput on all other systems, except CD
Water Manometer
Used for testing crankcase vacuum and exhaust back pressure
Inductive Tachometer
Used for checking the operating speed (RPM) of an engine
Ammeter Set
Used for checking current flow in charging and cranking circuits
Cylinder Leakdown Tester
Used for checking combustion retention and if cylinder, piston, rings, or valves are worn
Oil Pressure Test Kit
Used to test/verify oil pressure on pressure lubricated engines
Electric Starter Service Kit
Used to service all electric starters, including solenoid shift
Electric Starter Service Kit
Used to remove and reinstall drive retainers on most inertia drive starters
Rectifier-Regulator Tester
Used for testing rectifier-regulators
Spark Advance Module Tester
Used to test the SAM on engines with Smart Spark
Vacuum/Pressure Tester
Used like the water manometer but easier to operate, transport, and maintain
Spanner Wrench
Used for installing push rods or rotating crankshaft
Engine Analysis Kit
Used for testing running conditions of Kohler engines in applications
2.2
SPX Part No.
KO1044
KO1046
KO1047
KO1048
KO3216
KO3218
KO3219
KO3220
KO3226
KO1049
KO3221
KO3222
KO3223
OEM6200
KO1000A