Omron FHV7H-C004-H19-MC Hardware Setup Manual page 232

6 I/O Interface
Wiring
Describes the connection processing to connector hood of shield as the following. The connection
processing is changed according to the transfer speed.
• 10 BASE-T/100 BASE-TX
Connect both ends of the cable shield to the connector hood. Or, connect only the shield of one end
of the cable, switching hub side, to the connector hood.
• 1000 BASE-T
Connect both ends of the cable shield to the connector hood.
6-38
FH Series Vision System Hardware Setup Manual (Z366-E1)