Omron FHV7H-C004-H19-MC Hardware Setup Manual page 186

5 Setup and Wiring
Camera Cable
Right-angle Camera Cable
Bend resistant Camera Cable
Bend resistant Right-angle Camera Cable
Long-distance Camera Cable
Long-distance Right-angle Camera Cable
Installation in a Control Panel
• Make sure to tighten all screws in mounting.
• For good ventilation, provide a clearance of 50 [mm] or more above the Sensor Controller away
from other devices in the normal floor mounting. For the right and left sides, provide a clearance of
30 [mm] or more, and for the back side, 15 [mm] or more. These clearances are also required when
mounting multiple Sensor Controllers side by side. For the back mounting, the back-side clearance
of 15 [mm] is not required.
l Side Mounting
5-32
Name
FZ-VS3
FZ-VSL3
FZ-VSB3
FZ-VSLB3
FZ-VS4
FZ-VSL4
• Left side
4-M4 depth 4.5 (mounting screw hole)
143
Minimum bending
Model
radius
69 [mm]
78 [mm]
• Right side
19.2
19.5
20.1
* Recommended tightening torque: 1.2 N•m to 1.3 N•m
* The tolerance is ±0.2 mm.
FH Series Vision System Hardware Setup Manual (Z366-E1)
Connector length
30 [mm]
42 [mm]
(Unit: mm)
4-M4 depth 4.5 (mounting screw hole)
143
182.5