Kodak 6850 User Manual page 33

Error Message
Cannot load DLLs. Insufficient
memory.
Cannot load the file
SDKColorMatch.dll.
Please reinstall the software.
Cannot load the file
SDKUsbCtrl.dll.
Please reinstall the software.
Cannot open the USB port.
Please check the printer
cables and power.
Cannot access the file or read
the data.
Parameter error, such as
undefined tag or insufficient
data.
The printer with the selected
ID number cannot be found.
The printer is not ready.
May 4, 2005
Description or Cause
There is not enough memory available
for the calibration software to load all
the necessary DLLs.
A file required by the calibration
software is missing or corrupt.
A file required by the calibration
software is missing or corrupt.
The software is unable to
communicate with the printer.
A file required by the calibration
software is missing or corrupt.
An internal error has occurred within
the calibration software.
The calibration software is unable to
find the printer with the selected
Printer ID.
The printer is not ready for
calibration.
Calibrating the Printer
Possible Solution
• Close any other open programs to free up
memory.
• Reboot the computer then run only the
calibration software.
Uninstall then reinstall the calibration
software. See "Uninstalling the Calibration
Software" on page 3-8 and
Calibration Software" on page
Uninstall then reinstall the calibration
software. See "Uninstalling the Calibration
Software" on page 3-8 and
Calibration Software" on page
• Check that the printer cables are secure.
• Check that the printer is turned on and the
operator panel Ready light is illuminated.
• Power the printer off then on.
• Reboot your computer.
Uninstall then reinstall the calibration
software. See "Uninstalling the Calibration
Software" on page 3-8 and
Calibration Software" on page
• Close the calibration software and try
calibrating the printer again.
• Uninstall then reinstall the calibration
software. See "Uninstalling the Calibration
Software" on page 3-8
Calibration Software" on page
• Check the Kodak Web site for an updated
version of the calibration software.
• Close the calibration software.
• Check that the printer cables are secure.
• Check that the printer is turned on and the
operator panel Ready light is illuminated.
• Run the calibration software and try
choosing the printer again.
• Check that the printer cables are secure.
• Check that the printer is turned on and the
operator panel Ready light is illuminated.
"Installing the
3-1.
"Installing the
3-1.
"Installing the
3-1.
and "Installing the
3-1.
3-9