ClearSounds PHONE A1600 Operating Manual page 88

Remote Access
You can access many features of your answering machine
remotely from any touch tone phone. A four-digit Security ID/
PIN is required to access the system and the factory default
code is 0000. To enter remote access:
Dial your phone number from any touch tone phone.
When the Announce1/Announce2 message starts to play,
you may enter the remote access mode by inputting a
then the Security ID/PIN. If you enter the ID/PIN incorrectly,
the machine will ask you to enter the ID/PIN again. You are
given 2 more attempts to correctly enter the ID/PIN before the
line is disconnected. After you enter the ID/PIN, the system
will play the menu of commands. You can then follow the
commands to operate.
Note: It is best to stop playing messages before hanging
up the phone.
Reminder: Your answering machine must be turned ON in
order to use remote access.
TROUBLESHOOTING
No dial tone
1. Check that all phone cord connections and AC adapter are
securely plugged into the phone, wall jack and electric
outlet.
2. Check that the handset batteries are installed properly and
are in full power (page 19).
3. Check that the phone is in the correct dialing mode: tone or
pulse (page 30 or 52).
4. Plug another phone into the wall jack to make sure your
phone service is working.
Nothing appears on the display
1. Check that the handset batteries are installed properly and
are in full power.
88 – ENGLISH
and