Information On Use In Damp Conditions; Assembly Of Mounting Kit With Thread; Assembly Of Mounting Kit Without Stroke Limiter; Assembly Of Mounting Kit With Stroke Limiter - GEM 1205 Instruction Manual

9 Assembly and installation
1

9.2 Information on use in damp conditions

The following information is intended to help when installing
and operating the product in damp conditions.
1. Lay cables and pipework so that no condensate or rain
water that remains on the pipework / cables can enter the
cable glands or plugs of the product.
2. Check that all cable glands or plugs are positioned cor-
rectly
3. Check the sealing ring 1 for any damage and correct posi-
tioning before tightening the cover.

9.3 Assembly of mounting kit with thread

1. Before beginning assembly, check the type of mounting
kit.

9.3.1 Assembly of mounting kit without stroke limiter

1. Screw in adapter 2 using wrench surface 1.
2. Screw in guide piece 3 using the wrench surface.
GEMÜ 1205
2
A
1
1
2

9.3.2 Assembly of mounting kit with stroke limiter

1. Screw in adapter 2 using wrench surface 1.
2. Set stroke limiter to the desired height using wrench sur-
face 4.
3. Secure nut 5 against the actuator top.
4. Only use thread sealing ring 6 for installation of stroke
limiters in case of control functions 2 and 3

9.4 Assembly of mounting kit without thread

1
1. Insert spindle of mounting kit 1 into actuator.
2. Carefully knock down the spindle of mounting kit 1 with
an appropriate tool 2 until it stops.
3. Screw in guide piece 3 using the wrench surface.
4. Mounting kit 1 is correctly assembled.
3
9.5 Assembly and installation of the electrical position
indicator
Danger of explosion
▶ Danger of death or severe injury.
●
●
10 / 20
1
4
5
6
2
3
DANGER
Do not use the product as a step or
foothold.
Prior to commissioning, ensure that
the cover is fully closed and that the
housing and the O-ring are not dam-
aged.
www.gemu-group.com
2
1
4