Removing/Inserting The Simatic Memory Card - Siemens SIMATIC S7-1500 System Manual

Automation system
Hide thumbs Also See for SIMATIC S7-1500:
Table of Contents

Advertisement

Commissioning
9.3 Commissioning procedure
9.3.1

Removing/inserting the SIMATIC memory card

Requirement
The CPU only supports pre-formatted SIMATIC memory cards. As applicable, delete all
previously stored data before using the SIMATIC memory card. Additional information about
deleting the contents of the SIMATIC memory card can be found in the section, SIMATIC
memory card - overview (Page 149).
In order to work with the SIMATIC memory card, first ensure that the SIMATIC memory card
is not write-protected. For this purpose, slide the slider out of the lock position.
If the inserted SIMATIC memory card is write-protected, the CPU's display outputs the
symbol in the "Memory card" category and writes a corresponding alarm in the lower level of
the category.
Insertion of the SIMATIC memory card
1. Open the front cover of the CPU.
2. Ensure that the CPU is either switched off, or in the STOP mode.
3. Insert the SIMATIC memory card, as depicted on the CPU, into the slot for the SIMATIC
memory card.
Figure 9-1
4. Insert the SIMATIC memory card with light pressure into the CPU, until the SIMATIC
memory card latches.
110
Slot for the SIMATIC memory card
S7-1500 Automation System
System Manual, 02/2014, A5E03461182-AB

Advertisement

Table of Contents
loading

Table of Contents