Table of Contents
Advertisement
RUGGEDCOM i801
Installation Guide
Section 2.7
Configuring the Device
Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROS interface. For more information about configuring the device, refer to the
RUGGEDCOM ROS User Guide associated with the installed software release.
Section 2.8
Inserting/Removing the MicroSD/MicroSDHC Card
The RUGGEDCOM i801 accepts a microSD/microSDHC card to support the following features:
• Configuration update and backup
• Redundant firmware image
• Greatly expanded logging capability
• Fault-tolerant firmware update
CAUTION!
Configuration hazard – risk of data loss. The microSD/microSDHC card must not be removed or
replaced during normal operation of the device. Make sure the device is powered down before
removing or inserting the card.
CAUTION!
Mechanical/electrical hazard – risk of damage to the microSD/microSDHC card.
• Do not expose the microSD/microSDHC car to extreme temperatures or humidity.
• Do not expose the microSD/microSDHC card to large magnetic or static electric fields.
• Do not bend or drop the microSD/microSDHC card.
CAUTION!
Security hazard – risk of unauthorized access and/or exploitation. Make sure to remove the microSD/
microSDHC card before decommissioning the device or sending the device to a third-party.
To insert or remove a microSD/microSDHC card, do the following:
1.
Power down the device.
2.
Unscrew the retention screw and remove the access plate.
Configuring the Device
Chapter 2
Installing the Device
11
Advertisement
Table of Contents
