Dimplex ZWU 06E Installation And Operating Instructions Manual page 34

Setup
Substitute temperature
Menu → Setup → Living comfort
Setting for selecting the outdoor temperature for the target charge rate in the event of a faulty external sensor. This setting enables the system's heat
demand to be controlled manually if the external sensor fails.
Factory setting: automatic if the outdoor temperature is available, adjustment range: -25°C to +25°C
Runtime (only shown with the classic charging model)
Menu → Setup → Living comfort
Setting for selecting the runtime in hours once the main release starts, for starting up the classic charging models faster after a prolonged power cut.
Enter the number of hours that have passed since the night-time release was last started here.
Example: setting in the morning at 11:00 upon startup, night-time release at 22:00 → 13 hours.
Factory setting: automatic, adjustment range: 0 h to 23 h
Intensity daytime charge (only shown with the classic charging model)
Menu → Setup → Living comfort
Setting for selecting the intensity of the daytime post-charging with the classic charging models; forward control with timer function and backward control.
Factory setting: 90%, adjustment range: 0 % to 100 %
Date/Time (only shown with the intelligent charging model)
Menu → Setup → Date/Time
The time is used to control the operating modes and week programs based on a schedule.
If the device is being put into operation for the first time, or if it has been disconnected from the power supply for a relatively long time, it is essential
to check that the date and time have been set correctly. (Brief power cuts lasting up to one day are covered by the power reserve)
34
Setting the date/time on the control unit:
1. Select Menu → Setup → Date/Time.
2. Press Chng.
3. Using the arrow keys [</>], select the desired parameters one after the other until they flash, meaning they are
active. Then change them using the plus or minus key [+/-].
4. Press Save.
→ The time and the date will be set.