Week program
For individually changing the times for the heat level during the week.
A week program can be used to set which heat level should apply at which time during the week. Week program 1 has been defined as the factory
setting. The four available week programs can be adjusted if required. The times can be changed in 15-minute increments.
A fully programmed entry consists of the following:
• Switching time: time at which the system should switch to the new operating mode (e.g. 06:00)
• Switching action: states the new heat level
• For day: states the days on which the entry should take effect (e.g. Mo, Tu, Th, Fr)
Selecting the week program:
1. Select Menu → Operation → Week program → press >>.
2. Using the plus or minus key [+/-], select the week program that you wish to change.
3. Press >>.
4. Using the plus or minus key [+/-], select the entry that you wish to change, e.g. Entry 2.
5. Press Act to update the week program.
6. Press Edit.
7. Using the plus or minus key [+/-] and the arrow key [>], make your desired changes to the time and heat level →
press >.
8. Using the plus or minus key [+/-] and the arrow key [>], make your desired changes to the days of the week.
The plus key [+] activates the switching point on the day in question (the starting letter of the day of the week is
displayed). The minus key [-] deactivates the switching point on the day in question ("–" is shown instead of the
letter)
9. After setting the seventh day (Sunday), press Save.
→ The changes to the week program will be set.
To add a new entry to a week program, select Add at point 6 in the list above.
To delete an entry from a week program, select Del here.
Points 7 and 8 from the list above are carried out in the same way.
31