Gas Hoses: Visual Inspection For Damage - Skoda Octavia II 2004 Maintenance Manual

– Check the gasket ring -2- in the filter housing -1- and replace
if necessary.
– Insert the new paper filter -3- in the filter housing -1-.
– Press the filter housing -3- into the flange -2- up to the stop
-in direction of arrow B-.
– Secure the filter housing -3- with the circlip -1-.
Note
Make sure that the circlip safely locks in place in the slot of the
filter housing.
– Screw down the evaporator with the two screws.
Tightening torque: 10 Nm.
– Screw down the screwed connection of the gas line on the gas
inlet of the filter housing.
Tightening torque: 10 Nm.
– Fit the plug onto the high-pressure valve -N372- .
– Install the battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
For vehicles up to 12/2010 (emission level EU-4)
– Install liquefied petroleum gas control unit ⇒ 1.6/72 kW; 75
kW engine; Rep. gr. 24 .
– Connect the plug for the liquefied petroleum gas control unit
-1- and secure it with the securing mechanism -2-.
Continued for all vehicles
– Install air filter ⇒ 1.6/72 kW; 75 kW engine; Rep. gr. 24 .
– Activate gas system
⇒ "3.17.8 Activate gas system", page 98
– Carry out a leak tightness test on the liquefied petroleum gas
system (LPG)
⇒ "3.17.3 Check LPG gas system for leaks", page 86
3.17.11 Gas hoses: Visual inspection for dam‐
age
– Check gas hoses for chafing points and any kind of damage.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
– Check gas hoses for porosity.
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
.
.
Maintenance - Edition 01.2018
103