Skoda Octavia II 2004 Maintenance Manual page 123

♦ Filling device (e.g. -VAS 6291- )
Gear oil ⇒ electronic catalogue of original parts
– Raise vehicle.
– For changing use the filling device (e. g. -VAS 6291- ).
– Place the catch pan under the vehicle.
Note
A rag must be laid -arrows-on the cross member
♦
If the oil gets onto the cross member or into the recesses at
♦
the cross member, it must be removed immediately.
– Release screw for oil inspection -B-. (shown on a removed
final drive for purposes of clear presentation).
– Screw out oil drain plug -A-.
– Drain oil.
– Screw in drain plug -A- using a new sealing ring and tighten to
38 Nm.
– Screw in adapter -A- up to the stop into the hole of the check
screw.
– Lock angular piece -B- with adapter.
– Pull hose above the drive shaft.
The hose must not sag. It must come out above the left rear wheel.
– Lower the vehicle.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Maintenance - Edition 01.2018
4. Gearbox
119