With Respect To The Correctness Of Information In This Document. Copyright By Škoda Auto A. S.� Replacing The Timing Belt Or Also The Tensioning Roller - Skoda Octavia II 2004 Maintenance Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
Engine with identification characters CLCA, CLCB, CFHC and
CFHF. The engine identification characters and the engine num‐
ber are located at the joint separating the engine/gearbox.
3.3 Visual inspection of engine and parts in the engine compartment for leaks and damage
– Inspect engine and parts in the engine compartment for leaks and damage (from above and from below).
– Inspect all lines, hoses and connections of the fuel system and of the cooling and heating system for leaks, chafing points, porous and brittle joints.
– Inspect gearbox or final drive (s) and four-wheel drive clutch for leaks (e.g. drain plug, drive shafts, shift linkage etc.).
– Inspect steering, sealing boots of track rod ends as well as steering boots for damage and correct installation.
– Inspect boots of steering joints for damage, leaks and correct installation.
3.4 Replacing the timing belt or also the tensioning roller
– Remove and install the timing belt and also the tensioning roller as required ⇒ relevant engine ; Rep. gr. 13 .
50
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�