Skoda Octavia II 2004 Maintenance Manual page 114

Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
First of all the ATF in the overflow tube -arrow 2- drains off.
If more ATF drips out of the ATF inspection opening (approx. 1
drop per second) via the overflow tube before the ATF has
reached 40°C, the ATF level is correct.
– Fit ATF inspection plug -arrow 1- with a new gasket ring and
tighten to 27 Nm. This completes the ATF test.
Note
At the latest at 45 °C (in hot climate countries 50 °C) the ATF
inspection plug must be closed again.
If no ATF flows out at the ATF inspection opening up to 45 °C, the
ATF must be topped up
– End function "08 - read measured value block".
– Tip "06 - End output".
– Switch off ignition and unplug diagnostic connector.
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
Fill with ATF
Special tools and workshop equipment required
♦ ATF filling system (e. g. -V.A.G 1924- ) - for gearbox with filler
tube (vehicles up to 05.06)
♦ Adapter for oil filling - VAS 6262- or -VAS 6262A- and adapter
for ATF oil filling - VAS 6262/2- - for gearbox without filler tube
(vehicles as of 06.06)
♦ Protective goggles
Note
♦ Pay attention to all the notes and test conditions
⇒ page 108 .
The ATF filler tube is no longer available on gearboxes as of
♦
production date 06.06 -arrow-.
– Fill ATF filling system with ATF for the automatic gearbox 09G.
WARNING
The ATF filling system must be clean and the ATF must not be
mixed with other ATF oils!
– Attach the reservoir of the ATF filling system as high as pos‐
sible to the vehicle.
For gearbox with filler tube (vehicles up to 05.06)
110
4. Gearbox
⇒ page 110 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�