Visual Inspection Of Engine And Parts In The Engine Compartment For Leaks And Damage - Skoda Rapid NH 2013 Maintenance, Workshop Manual

Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
Engine with identification characters CUSB, CXMA. The engine
code and engine number are located on the separating layer be‐
tween the engine and the transmission.
In addition, a sticker with the "engine identification characters"
and "serial number" is affixed to the top toothed belt guard.
3.3 Visual inspection of engine and parts in
the engine compartment for leaks and
damage
Note
Carry out the corresponding repair procedure on all the de‐
♦
fects which are found (repair measure).
In the event of a loss of fluid, which was not caused by the
♦
current consumption, determine the cause and eliminate it
(repair measure).
Engine compartment and components in the engine compartment
from above:
– Inspect engine and parts in the engine compartment for leaks
and damage.
– Inspect all lines, hoses and connections of the following sys‐
tems and circuits for leaks, chafing points, porous and brittle
joints:
♦ for fuel system,
♦ for cooling and heating system
♦ for oil system
♦ for air conditioning system
♦ for suction and air system
♦ for exhaust system
♦ for brake system
⇒ "5.3 Inspecting brake system for leaks and damage",
page 118
– Inspect gearbox or final drive for leaks (e.g. inspection and
drain plug, shift linkage, drive shafts)
⇒ "4.1 Check final drive and joint boots for leaks and damage",
page 111 .
Engine compartment and components in the engine compartment
from below:
– Remove the noise insulation.
– Inspect engine and parts in the engine compartment for leaks
and damage.
– Inspect all lines, hoses and connections of the following sys‐
tems and circuits for leaks, chafing points, porous and brittle
joints:
54