Kohler K-5402T-0 Homeowner's Manual page 51

Pressing and holding toilet
change settings according to below B/C/E/F/O.
B – Cover OPEN/CLOSE ...detection distance setting
· Holding and pressing this button to set auto cover detection distance
1. Night light quick blink once is close distance (short beep)
2. Night light quick blink twice is middle distance (short beep)
3. Night light quick blink three times is far distance (short beep)
4. Night light slow blink once to turn off auto cover open function (long beep).
C – Seat OPEN/CLOSE ...deodorizing function setting
· Holding and pressing this button to set deodorizer function ON/OFF status
1 Night light quick blink once indicate deodorizer functions is ON (short beep)
Night light slow blink once indicate deodorizer functions is OFF (long beep)
2
E – Flush full... auto flush setting
Hold g and pressing this button to set auto flush function ON/OFF status. in
•
Night light quick blink once to activate auto flush function (short beep)
1.
Ni gh t light slow blink once to deactivate auto flush function (lon
2.
F – Seat temperature...energy saving setting
• Holding and pressing this button to set energy saving function ON/OFF status.
1. Night light quick blink once to activate energy saving function (short beep)
2. Night light slow blink once to deactivate energy saving function (long beep).
O – UV sterilization (UV light)... UV auto sterilization setting
• Holding and pressing this button to set auto sterilization function ON/OFF status.
1. Night light quick blink once to activate auto sterilization function (short beep)
2. Night light slow blink once to deactivate auto sterilization function (long beep)
Before change B/C/E/F/O setting after a certain time frame, holding and pressing
until one short beep, night light blink 3 times.
M – Wand move ... wand clean setting
• Holding and pressing manual clean wand function under unseated status, wand extend, perform manual clean on nozzle,
holding and pressing this button again or press STOP button to deactivate this function.
Remote Battery Usage and Exchange
Remote docking station uses 4 pieces of AA alkali batteries.
•
• When battery is low, red LED blinking on docking station, indicates
customer to change battery.
• Note
1. Batteries +/- poles shall be oriented as shown on the diagram on remote.
2. Do not mix new and old batteries.
3. Please use alkali batteries.
Others
Do not place remote in a location where water might be splashed on the remote or immerse within water.
Do not place remote around dryer, hair dryer etc. appliances to prevent remote normal operation by interference.
Place remote back to docking station on the wall after using remote.
Avoid remote from dropping during operation.
Guarding function: remote could be locked with docking station. Specific method refers to installation manual.
Kohler Co.
button until heard one short beep, night light blink 3 times simultaneously, release button, then
g beep)
51
button on toilet side panel
Red light blink
1302892-T01-B