Qos Policer Setup; Add Or Edit A Qos Policer - ZyXEL Communications AX Series User Manual

12.7 QoS Policer Setup

Use this screen to view QoS policers that allow you to limit the transmission rate of incoming traffic and
apply actions, such as drop, pass, or modify, to the DSCP value of matched traffic. Click Network Setting
> QoS > Policer Setup. The screen appears as shown.
Figure 154 Network Setting > QoS > Policer Setup
The following table describes the labels in this screen.
Table 78 Network Setting > QoS > Policer Setup
LABEL
Add new Policer Click this to create a new entry.
#
Status
Name
Regulated
Classes
Meter Type
Rule
Action
Modify

12.7.1 Add or Edit a QoS Policer

Click Add New Policer in the Policer Setup screen or the Edit icon next to a policer to show the following
screen.
Chapter 12 Quality of Service (QoS)
DESCRIPTION
This is the index number of the entry.
This field displays whether the policer is active or not. A yellow bulb signifies that this policer is
active. A gray bulb signifies that this policer is not active.
This field displays the descriptive name of this policer.
This field displays the name of a QoS classifier
This field displays the type of QoS metering algorithm used in this policer.
These are the rates and burst sizes against which the policer checks the traffic of the member
QoS classes.
This shows how the policer has the Zyxel Device treat different types of traffic belonging to the
policer's member QoS classes.
Click the Edit icon to edit the policer.
Click the Delete icon to delete an existing policer. Note that subsequent rules move up by one
when you take this action.
AX/DX/EX/PX Series User's Guide
259