The Qos Settings Summary Screen; Figure 42 Advanced Setup > Qos > Qos Settings Summary; Table 28 Advanced Setup > Qos > Qos Settings Summary - ZyXEL Communications P-660RU-T1 v3 User Manual

Table 27 Advanced Setup > QoS
LABEL
DSCP
Remarking
802.1p
Remarking
Queue #
ADD
DELETE
CANCEL

11.2.1 The QoS Settings Summary Screen

Use this screen to display a summary of rules and actions configured for the ZyXEL Device.
In the Advanced > QoS screen, click the QoS Settings Summary button to open the
following screen.
Figure 42 Advanced Setup > QoS > QoS Settings Summary
The following table describes the labels in this screen.
Table 28 Advanced Setup > QoS > QoS Settings Summary
LABEL
Rules
#
Active
Physical Ports
Destination MAC
and IP/Mask Port
Ranges
Source MAC and
IP/Mask Port
Ranges
Protocol ID
VLAN ID
IPP/TOS (DSCP)
P-660RU-Tx v3 User's Guide
DESCRIPTION
Specify a DSCP number between 0 and 63 to re-assign the priority level to matched
traffic.
Select a priority level (0 to 7) to re-assign the priority level to matched traffic.
Specify a Low, Medium, High or Highest queue tag to matched traffic. Traffic
assigned to a higher queue gets through faster while traffic in lower queues is
dropped when there is network congestion.
Click this to add the rule.
Click this to remove the rule.
Click this to restore previously saved settings.
DESCRIPTION
This is the rule's index number.
This shows whether the rule is enabled or disabled.
This is the physical port associated with the rule.
This is the port range for destination MAC address and IP address.
This is the port range for source MAC address and IP address.
This is the protocol ID associated with the rule.
This is the VLAN ID associated with the rule.
This shows the IPP/TOS or DSCP settings.
Chapter 11 Quality of Service (QoS)
103