Table of Contents
Advertisement
Preparation
Connecting
Note
Avoid plugging the AC power cord into the AC
input connector while connecting the optional
Sony AC adaptor (AC-300MD) to the DC input
connector.
1
Make sure that the (On)/
is set to
(Standby).
2
Remove the cable cover (L).
Slide down the cable cover (L) while sliding
the slide locks (2 pcs), which are located at
the bottom of the monitor, in the direction of
the arrow.
Note
Do not forcibly pull cable covers. Otherwise,
the cable covers may be damaged or the
monitor may fall over.
3
Connect the connection cable.
The connection cable should be wired with
the cable holder.
4
Connect the AC power cord.
(Standby) switch
Cable cover (L)
When using the supplied AC power cord
Slide the shutter of the AC power connector
to show the AC input connector, and plug the
AC power cord into the AC input connector.
AC input connector
Shutter
AC power cord
Plug holder for the
supplied AC
power cord
When using the optional AC adaptor
Slide the shutter to show the DC input
connector and insert the DC connector to the
DC input connector until it locks. Then, plug
the AC power cord into the optional AC
adaptor.
Shutter
DC input connector
23
DC connector
Advertisement
Table of Contents
