Preparation; Connecting - Sony LMD-X3200MD Instructions For Use Manual

Preparation

Connecting

Note
Avoid plugging the AC power cord into the AC
input connector while connecting the optional
Sony AC adaptor (AC-300MD) to the DC input
connector.
1
Make sure that the  (On)/
is set to (Standby).
2
Remove the cable cover (L).
To remove the cable cover (L), slide it down
while sliding the slide locks (2 pcs), which are
located near the  on the cover, in the
direction of the arrow.
Note
Do not forcibly pull cable covers. Otherwise,
the cable covers may be damaged or the
monitor may fall over.
3
Connect the connection cable.
The connection cable should be wired with
the cable holder.
4
Connect the AC power cord.
Slide the shutter of the AC power connector
to show the AC input connector, and plug the
AC power cord into the AC input connector.
(Standby) switch
Cable cover (L)
AC input connector
Shutter
AC power cord
Plug holder for the
supplied AC
power cord
When using the optional AC adaptor
Slide the shutter to show the DC input
connector and insert the DC connector to the
DC input connector until it locks. Then, plug
the AC power cord into the optional AC
adaptor.
Shutter
DC input connector
AC IN connector
AC power cord
Plug holder for the supplied
AC power cord
Note
When using the AC power cord, make sure to
use the supplied plug holder for the AC
23
DC connector