Table of Contents
Advertisement
AC IN connector
AC power cord
Plug holder for the supplied
AC power cord
Note
When using the AC power cord, make sure to
use the supplied plug holder for the AC
power cord and insert it until the fixing lever
locks. When using the AC adaptor, insert the
DC connector into the monitor until it locks.
Otherwise, the cable may fall out and the
image may disappear.
5
Slide the cable cover (S) in the direction of
the arrow to remove it.
Slide the cable cover (S) while pressing
the bottom center of the cover
When the cable cover (S) is removed, it can
be used as a cable outlet for the
connection cable and AC power cord.
To prevent losing the removed cable
covers, store them appropriately.
To attach the cable covers, slide the covers
in the opposite direction from when you
removed them.
6
Attach the cable cover (L).
Slide the cable cover (L), while sliding the
slide locks (2 pcs), which are located at the
bottom of the monitor, in the reverse
direction of step2.
Notes
After attaching the cable cover (L), check
that the slide locks (2 pcs) return to the
original position. The cable cover (L) may
fall off if it is improperly locked.
If you use a connection cable that is bigger
than the cable holder or cable cover and it
cannot be fit in, do not secure it in the
cable holder and use the cable with the
cable cover removed.
Caution
This unit with the cable covers attached
conforms to the waterproofed standard. (See
page 37)
Be sure not to use the unit with the cable covers
removed since waterproofed performance is not
guaranteed.
Cautions for splash-proof performance
Splash-proof test has been conducted only on
water.
Splash-proof performance against liquids such
as drugs and body fluids is not ensured.
If liquids that are assumed to cause risks such as
an infection have entered the unit, dispose of the
unit according to the regulations of the country,
region, and hospital.
To unplug the AC power cord
Press the (On)/
(Standby) side to set the unit to the standby
state, then unplug the AC power cord from the
AC power plug holder by holding both sides of
the fixing levers of the holder to release the lock.
When the optional AC adaptor is used, set the
unit to the standby state, then unplug the AC
power cord from the AC adaptor before
disconnecting the DC connector from the unit.
24
(Standby) switch to the
Advertisement
Table of Contents
