Table of Contents
Advertisement
Preparation
Connecting
1
Make sure that the (On)/
is set to
(Standby).
2
Remove the cable cover (L).
Slide down the cable cover (L) while sliding
the slide locks (2 pcs), which are located at
the bottom of the monitor, in the direction of
the arrow.
Note
Do not forcibly pull cable covers. Otherwise,
the cable covers may be damaged or the
monitor may fall over.
3
Connect the connection cable.
The connection cable should be wired with
the cable holder.
4
Plug the AC power cord into the AC input
connector.
(Standby) switch
Cable cover (L)
AC input connector
AC power cord
Plug holder for the
supplied AC power cord
Note
Make sure to use the supplied plug holder
for the AC power cord and insert it until the
fixing lever locks. Otherwise, the cable may
fall out and the image may disappear.
5
Slide the cable cover (S) in the direction of
the arrow to remove it.
Slide the cable cover (S) while pressing
the bottom center of the cover
When the cable cover (S) is removed, it can
be used as a cable outlet for the
connection cable and AC power cord.
To prevent losing the removed cable
covers, store them appropriately.
To attach the cable covers, slide the covers
in the opposite direction from when you
removed them.
23
Advertisement
Table of Contents
