F6 Exit Function; F7 Internal Value Display Mode; F8 Weight Hold Mode Setting - Excell H3 Series User Manual

EXCELL PRECISION CO., LTD.
F5
Function
Print after removing goods (OK
r n p 12
mode)
r n p 13
MODBUS Function
Stable transmission, only weight
r n p 14
value is transmitted
Enter serial number, reply serial
r n p 15
number, weight
Continuous Output Contains High,
r n p 16
Low, Ok Status
 <CR>=ASCII carriage return character, hexadecimal is 0D.
<LF>=ASCII line feed character, hexadecimal is 0A.

3-3 F6 Exit Function

Use or
setting.

3-4 F7 Internal Value Display Mode

Use or
again will see F7.

3-5 F8 Weight Hold Mode Setting

Use key or
Press key
Press key
Press key
Press key
0201813X
Press
RS232 transmit only "OK" item weight after item is removed.
No transmission while in "HI" or "LO".
Use MODBUS to transmit weight, and need to use with F11
ID Code Setting,
After return to zero, transmit next stable weight's weight
value only.
Enter serial number and put the weight on. Once it is stable,
return serial number and weight
RS232 transmit continuously containing High, Low, Ok
Status. Keypad has no effect.
to select F6. Then press
to select F7. Then press
key choose F8
Press key
Press key
18
key Press
to count down to zero and exit the
to display internal value. Press
 Before setup, please switch the SWA1 on
MINI JUMPER to ADJ position
 After setup, please switch the SWA1 on
MINI JUMPER back to LOCK position

In hold mode, press
hold value as shown on display.
(It's not related to the settings of F5
transmission mode, but it needs to select the
proper Baud rate according to the
transmission of the receiver.)
(To setup transmission rate, please refer to
F5 RS-232 Interface Output Setting (option))
Use key to select a value from
hold 0 ~ hold 5 and then press
complete setup.
key Press key
twice after zeroing
key, to print the
key to
ZSME300000366