Excell H3 Series User Manual page 10

EXCELL PRECISION CO., LTD.
 Preset Single point (preset low limit only):
After "preset low limit" procedures is completed and the display shows
then press
single point" procedure is completed.
NOTE
_
A Setting for the status that LCD is on and the beeper beep:
0 = when stable, the beeper beeps and LCD is on.
1 = when stable, the beeper beeps; whether stable or not, LCD is on.
2 = whether stable or not, the beeper beeps and LCD is on.
3 = open warning device: when the weight is higher than HI value and the weight is
stable, LCD is on and Relay Card open.
B Setting for the beep status:
0 = No beep
1 = OK (when the weight is over Low Limit & under or equal to High Limit.), the beeper
beeps.
2 = When the weight is under or equal to Low Limit & over High Limit, the beeper beeps.
 Under Status in Preset Low Limit (preset single point only)
The BEEP, LCD mode should be fixed as follows:
 Warning device setting
Set HI value and value of the beep, LCD mode should be fixed as follows:
When the weight equals to HI value, Relay Card open and the weight is accumulated. Press CE
key to dismiss the warning sound and the range of accumulated weight is [000.000]~[999999].
 Clear warning accumulation
 Press
key first and then press
 Accumulated data is cleared automatically under following conditions
a. when shift among weight mode, counting mode and warning accumulation mode.
b. when shift the units
c. turn off the scale
 Set relay low output: L1 => low output; L0=> no low output
 LCD indication:
◆ To exit preset mode, please press
2. Recall Check-weighing Values
Press
Then press
Then press
Then press
0201813X
key again, the display shows
x x
_ _
A B
When over "Low Limit", the beeper beeps and
Whether stable or not, the beeper beeps and LCD indication is on
(not available in 4/5 key models)

A
(not available in 4/5 key models)
  

10d Low Limit
(not available in 4/5/10 key models)
key then press
key again
key again
key again
.
key to clear all accumulated data.
  
 
High Limit
key.
key  Recall "Low limit value"
 Recall "High limit value"
 Recall "Beeper value"
 Back to the beginning
9

. This means that the "preset
is off
ZSME300000366
. ,