Table of Contents
Advertisement
OTHERS
Troubleshooting
Symptoms
Power cannot be switched ON.
Recording is not possible.
Camera image does not appear on LCD monitor or in viewfind-
er.
Image shown on LCD monitor or in viewfinder is dark or blurred. • Adjust the brightness of the LCD monitor or viewfinder screen.
Playback does not start when the play button is pressed.
Cannot play back.
Cannot input an HDV/DV signal.
Noise interferes with playback video.
Sound is not output during playback.
Noise appears when playing back a tape recorded on another
unit.
The transient section between scenes recorded on other units
and those recorded on the GY-HD110 may appear disturbed.
The front section's audio level control doesn't work.
Cannot initialize (format) the SD memory card.
Battery alarm is displayed even if a fully charged battery pack
is put in.
Cassette cannot be ejected after the power is turned ON.
Time code or user's bits data not displayed.
The date and time are not displayed or recorded.
92
Remedy
• Is power supply connected correctly?
• Is battery pack recharged?
• Was the power turned ON immediately after being turned OFF?
Wait at least 5 seconds before turning the power ON again once it has been
turned OFF.
• Is the REC LOCK switch on the hundle set to ON?
• Is the switch on cassette set to "REC"? If it is set to "SAVE", set it to "REC".
• The Camera mode has not been selected. (The VTR indicator does not light.)
While the VTR indicator lights, press the MODE switch upward to turn on the
CAM indicator.
• The Camera mode has not been selected. (The VTR indicator does not light.)
While the VTR indicator lights, camera image will not be output.
Press the CAM/VTR switch upward to turn on the VTR indicator.
• Is the ND filter knob set to 2?
• Is the iris closed?
• Is the shutter speed too fast?
• Is the viewfinder cable correctly connected?
• In the Camera mode, is "STOP" indicated as the VTR operation mode indica-
tor?
When "STBY" is indicated, press the STOP button to display "STOP".
• Is the PB TAPE item on the VIDEO FORMAT menu screen set to a setting oth-
er than AUTO?
If this menu item and the tape format do not match, the tape cannot be played
back.
• Is the camcorder in VTR mode? (Is the VTR indicator lit?)
• Is the IEEE1394 switch set correctly?
• Video head may be clogged with dirt. Clean head with the special head clean-
ing tape. X See "Precautions for Use of Head Cleaning Tape" on page 7.
• Is the AUDIO SELECT item on the AUDIO menu screen set to CH3/4?
To output the sound of the recording, set to CH1/2.
• When a tape recorded on another unit is played back or used for recording,
this phenomenon may occur due to tracking errors.
• Is the CH-1/CH-2 AUDIO SELECT switch set to "AUTO"?
• Is the FULL AUTO switch set to "ON"?
• Is the SD memory card write-protected? X See page 31.
• Is the battery pack old?
• The capacity of the power supply may be insufficient. Check the power volt-
age.
• Is the TC/UB item on the LCD/VF [2/3] menu screen set to OFF?
If so, set to ON.
• Is the DISPLAY item on the TIME/DATE menu screen set to OFF?
Set to ON when the data should be displayed and recorded.
• Is the date and time setting made? X See "Setting and Displaying the Date
and Time" on page 37, 38.
How to Display the Hour Meter
OTHERS [2/2] menu screen
Drum usage hours (h)
Fan motor usage hours (h)
Information for Users on Disposal of Old Equipment
Attention:
This symbol is only valid in the European
Union.
[European Union]
This symbol indicates that the electrical and electronic equip-
ment should not be disposed as general household waste at
its end-of-life. Instead, the product should be handed over to
the applicable collection point for the recycling of electrical
and electronic equipment for proper treatment, recovery and
recycling in accordance with your national legislation.
By disposing of this product correctly, you will help to con-
serve natural resources and will help prevent potential nega-
tive effects on the environment and human health which could
otherwise be caused by inappropriate waste handling of this
product. For more information about collection point and recy-
cling of this product, please contact your local municipal
office, your household waste disposal service or the shop
where you purchased the product.
Penalties may be applicable for incorrect disposal of this
waste, in accordance with national legislation.
OTHERS
The drum and fan motor usage times are displayed in the
DRUM HOUR item and the FAN HOUR items on the OTH-
ERS [2/2] menu screen as the hour meters on this camcorder.
Use as an estimate for regular maintenance. X See page 7.
1.
Turn the POWER switch ON.
2.
Press the STATUS button for at least 1 second to display
the TOP MENU screen.
3.
Turn the SHUTTER dial, select the OTHERS.. item, and
press the SHUTTER dial.
The OTHERS [1/2] menu screen is displayed.
4.
Select the NEXT PAGE item on the OTHERS [1/2] menu
screen and press the SHUTTER dial.
The OTHERS [2/2] menu screen is displayed.
OTHERS [2/2] Menu Screen
DRUM HOUR item : Displays the drum usage hours.
FAN HOUR item
: Displays the fan motor usage hours.
5.
To return to the normal screen display, do one of the fol-
lowing:
• Press the STATUS button.
or
• Return to the TOP MENU screen, select the EXIT item
on the TOP MENU screen and press the SHUTTER
dial.
(Business users)
If you wish to dispose of this product, please visit our web
page www.jvc-europe.com to obtain information about the
take-back of the product.
[Other Countries outside the European Union]
If you wish to dispose of this product, please do so in accor-
dance with applicable national legislation or other rules in
your country for the treatment of old electrical and electronic
equipment.
93
- Quick Links:
- Main Features
Hide quick links:
Advertisement
Table of Contents
