Agilent Technologies E1439 User Manual page 209

Error messages
Warnings and errors are based on the value VI_ERROR
Error
Number
0x0000 AGE1439_SUCCESS
0x80000000+0x3FFC0800 AGE1439_ERR_BASE
AGE1439_ERR_BASE + AGE1439_BAD_COMMAND
0x0001
AGE1439_ERR_BASE + AGE1439_INVALID_HW_CONFIG
0x0002
AGE1439_ERR_BASE + AGE1439_PARM_ERROR
0x0003
AGE1439_ERR_BASE + AGE1439_NV_SAVE_ERROR
0x0004
AGE1439_ERR_BASE + AGE1439_DOWNLOAD_ERROR
0x0005
AGE1439_ERR_BASE + AGE1439_SERIAL_TIMEOUT
0x0006
AGE1439_ERR_BASE + AGE1439_BYTE_SWAP_ERROR
0x0007
AGE1439_ERR_BASE + AGE1439_START_ERROR
0x0008
AGE1439_ERR_BASE + AGE1439_HARDWARE_FAILURE
0x0009
AGE1439_ERR_BASE + AGE1439_WATCHDOG_RESET_ERROR
0x000a
AGE1439_ERR_BASE + AGE1439_NO_DATA_MEASUREMENT_IN_PROGRESS No data available, a measurement is in
0x0011
AGE1439_ERR_BASE + AGE1439_NO_DATA_MEASUREMENT_PAUSED
0x00102
AGE1439_ERR_BASE + AGE1439_NO_DATA_WAITING_FOR_TRIGGER
0x0013
AGE1439_ERR_BASE + AGE1439_NO_DATA_WAITING_ FOR_ARM
0x0014
AGE1439_ERR_BASE + AGE1439_NO_E1439_FOUND
0x0016
AGE1439_ERR_BASE + AGE1439_PROC_READY_TIMEOUT
0x0017
AGE1439_ERR_BASE + AGE1439_MEMORY_ALLOCATION_ERROR
0x0018
Parameter
Agilent E1439 Programmer's Reference
Description
No error, command succeeded
Base number for error values
Invalid command code
The hardware configuration is not supported
Invalid command parameter
Error while saving to non-volatile memory
Error while downloading new firmware
Serial bus time-out; hardware error
Incorrect byte-order setting
Start error
Hardware failure
Watchdog timer caused a hard reset, possibly
due to a hardware problem
progress.
No data available, the measurement is paused
No data available, trigger has not occurred
No data available, acquiring pre-trigger data
No AGE1439 found at specified logical
address
Time-out is waiting for AGE1439 command
processor
Memory allocation error
Error messages
199