Alarms; Fault / Warning Scenarios - Graco G3 Series Instructions Manual

Alarms

Any time a Fault / Warning occurs, a combination of LED's will illuminate to notify you there is a problem and help
identify the kind of Fault / Warning has occurred.
• To clear an fault, press and hold the RESET button on the display button pad for 3 seconds.
• To clear a warning press and immediately release the RESET button.

Fault / Warning Scenarios

The following pages describe the most likely fault / warnings you could receive.
Alarm Type
Low Level
Warning
HH
MM : SS
Low Level
Fault
HH
MM : SS
3A0414B
What it Looks Like
MM SS ##
!
ON OFF
HH : MM
C
1
P
C
C
1 2 3
2
P
C
P
3
P
SS ##
MM
!
ON OFF
HH : MM
C
1
P
C
C
1 2 3
2
P
C
P
3
P
What it Indicates
Level of grease in
reservoir is low and addi-
tional grease needs to be
added.
Unit continues to operate
as normal for a limited
period of time until a low
level alarm is triggered.
Level of grease in
reservoir is low and addi-
tional grease needs to be
added.
Unit stops pumping and
displays amount of accu-
mulated time since the
alarm was triggered.
Alarms
Solution
Add grease to reservoir.
After grease is
added, press
the RESET
button to clear
the warning.
Add grease to reservoir.
After grease
is added
user must
clear alarm
by pressing and holding
RESET button.
If repriming pump is
required, the low level
alarm time should be
decreased. See A-2:
Advanced Programming,
Low Level Alarm Time
page 41.
47