Run Mode - Graco G3 Series Instructions Manual

Run Mode

Run Mode
Time Control
After setup is complete, the G3 automatically begins to
run the OFF Time sequence (F
• The G3 runs the programmed OFF sequence.
(Notice the OFF Time LED on the display lights and
the OFF Time counts down on the display.)
• The example shown in F
of 1 hour and 32 minutes before the lubrication cycle
begins.
HH MM
ON
MM : SS
F . 16
IG
44
. 16).
IG
. 16 shows an OFF Time
IG
SS ##
!
OFF
HH : MM
• When the OFF Time count reaches zero, the G3
Automatic Lubrication Pump turns the pump on and
it runs for the programmed ON Time cycle (F
(Notice the ON Time LED is now illuminated on the
display.)
• The example shown in F
8 minutes and 42 seconds before the lubrication
cycle ends.
HH MM
ON
MM : SS
F . 17
IG
• When the ON Time count reaches zero, the pump
shuts off again and the system again runs OFF
Time cycle and the OFF Time LED is now again illu-
minated (F . 16).
IG
This sequence repeats itself until the device is
reprogrammed or an alarm occurs.
IG
. 17 shows an ON Time of
IG
SS ##
!
OFF
HH : MM
3A0414B
. 17).