Setting Up Printer In Sap R/3; Using The Label Files In Sapscript - Intermec EasyCoder 301 Installation And Operation Manual

Intermec easycoder 301: install guide

Hide thumbs Also See for EasyCoder 301:

Table of Contents

Setting Up Printer

in SAP R/3

Using the Label

Files in SAPscript

ERPLabel v. 2.0 for SAP R/3 – Installation & Operation Ed. 1

A standard printer is used – there is no special application running.

Set up the printer in standard configuration using the appropriate

port (serial – UART or parallel port).

For details on the setup of the printer driver in SAP R/3, please

consult the OSS Note Number 137069 (DP/FP) or 183777 (IPL).

A few steps will be required to use the ITF files in SAPscript.

• Upload the label file to SAPscript

• Adjust the SAPscript form

• Create an output device for the label printout

These steps are described in detail in the OSS Note Number 137069

and 183777.

For SAPscript setup, please note following:

• Define the specific device type to be used for the upload method,

LB_UBI for Fingerprint/Direct Protocol and LB_NT for IPL

printers.

• For printing, use a plain ASCII driver, e.g. Generic Text driver in

Windows

• Remove all Windows except MAIN

• To avoid unwanted break characters, use largest possible window

size, e.g. A3 or Legal. in Landscape mode.

ERPLabel for SAP R/3

Table of Contents