Using ERPLabel
Setup, cont'd.
ERPLabel v. 2.0 for SAP R/3 – Installation & Operation Ed. 1
Fingerprint tab
• Remove Setup Default
The ITF file will normally contain setup strings to set the printer to
the a number of parameters e.g. desired print mode, select media
type, print contrast, direct thermal/thermal transfer mode.
If the printer will use the same media type and size at all times, this
may not be necessary to send with every label. For these cases the
printer may be set up, as described in the printer's documentation.
The Remove Setup can then be set to "On".
ERPLabel for SAP R/3
Off
32