Selecting The Bit Rate; Adjusting The Zero Print Option - Intermec 6820 Series User Manual

—
Chapter 3 Maintenance
32

Selecting the Bit Rate

S If the PAPER OUT indicator is lit, the printer is set for "19.2K."
S If the same indicator stays dark, the printer is set for "9600 bps."
Press the FORM FEED button to toggle these bit rates.

Adjusting the Zero Print Option

S If the HEAD JAM indicator is lit, the zero print option is set for the
zero with a slash (4) to appear in printouts.
S If the HEAD JAM indicator stays dark, the zero print option is set for
the zero without a slash (0) to appear in printouts.
Press the SET PAGE button to toggle between these zero print options.
After selecting configurations, press both SET PAGE and LINE FEED
buttons and listen for a beep to take the printer out of the "Configuration
Mode." Warm-start the printer to reset it with the new configurations.
Protocol Binary Sequence
Protocol
NPCP (factory default)
Reserved
Reserved
Reserved
DTR no parity
DTR odd parity
DTR even parity
IrDA
Repeatedly press the LINE FEED button to increment the light sequence
to the protocol of choice (NPCP to IrDA).
Example
If the printer is set for "NPCP" (OFF, OFF, OFF), press the LINE FEED
button four times to increment the protocol selector to the "DTR no par-
ity" protocol (ON, OFF, OFF).
Repeatedly press the SET PAGE button to decrement the light sequence to
the protocol of choice (IrDA to NPCP).
Example
If set for "DTR no parity" protocol (ON, OFF, OFF), press the SET
PAGE button four times to return to "NPCP" (OFF, OFF, OFF).
After you have selected the protocol, press both the FORM FEED and
LINE FEED buttons and listen for a beep. This takes the printer out of
the Protocol Selection Mode. Warm-start the printer to reset it with the
new protocol.
PAPER OUT HEAD JAM
Indicator Indicator
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
6820 Series 80-Column Printer User's Manual
LOW BATT
Indicator
OFF
ON
OFF
ON
OFF
ON
OFF
ON