Intermec 6820 Series User Manual page 101

6820 Series 80-Column Printer User's Manual
Select User-Defined Character Set
A user-defined character set can be selected, after the Define User-Defined
Characters function is used to define the character set. Note hhis function is
only useful with the default SBCS Character Set.
Format
Decimal
27 37 1
Select Default Character Set
If the Select User-Defined Set function was previously set, this function
switches back to the default character set. Note this function is only useful
with the default SBCS character set.
Format
Decimal
27 37 0
Enable Printing of Codes 128-255
All codes (128–255) are treated as printable characters, rather than control
codes, with this function. This allows the use of these characters for user-
defined characters. A user-defined set must be selected, using the Select
User-Defined Set function, before these characters can print. Factory de-
fault disables printing of these codes. Note this function is only useful with
the default SBCS character set.
This function is only available when the default SBCS character set is se-
lected.
Format
Decimal
27 54
Disable Printing of Codes 128-255
This disables the printing of codes (128–255), set by Enable Printing of
Codes 128–255. By default, these codes are disabled.
Format
Decimal
27 55
Expand Printable Code Area
This function allows certain ASCII codes (00h to 1Fh) and codes (80h to
9Fh) to be printable when the variable n is set to the value of 1. This al-
lows the use of these codes for user-defined characters. If n = 0, the func-
tion returns these two ranges of characters to non-printable control codes.
A user-defined character set must be selected by ESC
Chapter 5
Hex
1B 25 01
Hex
1B 25 00
Hex
1B 36
Hex
1B 37
—
Control Code Definitions
ASCII
ESC "%" (1)
ASCII
ESC "%" (0)
ASCII
ESC "6"
ASCII
ESC "7"
%" (1), the Enable
"
85