Table of Contents
Advertisement
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2.
Back up all server data.
3.
Power down the server (Power down the server).
4.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5.
Do one of the following:
a. Extend the server from the rack (Extend the server from the rack).
b. Remove the server from the rack (Remove the server from the rack).
6.
Remove the access panel (Remove the access panel).
7.
Install the secondary low-profile PCIe slot riser cage.
8.
Install one of the following, as needed:
•
Expansion boards (Installing an expansion board in the secondary riser cage)
•
Controllers (Smart Array controller options)
9.
Install the access panel (Install the access panel).
10. Install the server into the rack (Installing the server into the rack).
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Power up the server).
Hardware options installation
99
Advertisement
Table of Contents
