Table of Contents
Advertisement
CAUTION: DIMMs and persistent memory modules are keyed for proper alignment. Align notches on the
DIMM or persistent memory module with the corresponding notches in the slot before installing the
component. Do not force the DIMM or persistent memory module into the slot. When installed properly, not all
DIMMs or persistent memory modules will face in the same direction.
CAUTION: Electrostatic discharge can damage electronic components. Be sure you are properly grounded
before beginning this procedure.
CAUTION: Failure to properly handle persistent memory modules can damage the component and the system
board connector.
IMPORTANT: Hewlett Packard Enterprise recommends that you implement best-practice configurations such
as clustered configurations for high availability (HA).
2.
Power down the server (Power down the server).
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Do one of the following:
a. Extend the server from the rack (Extend the server from the rack).
b. Remove the server from the rack (Remove the server from the rack).
5.
Place the server on a flat, level work surface.
6.
Remove the access panel.
7.
Open the DIMM slot latches.
8.
Install the persistent memory module.
9.
Install the access panel (Install the access panel).
10. Slide or install the server into the rack.
Hardware options installation
62
Advertisement
Table of Contents
