Table of Contents
Advertisement
12. Install the access panel (Install the access panel).
13. Install the server in the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server.
Installing an HPE Smart Array P816i-a SR Gen10 Controller option
Prerequisites
Before installing this option, be sure that you have the following:
•
The components included with the hardware option kit.
Additional cables, as required. For more information, see Cabling.
•
•
T-15 Torx screwdriver.
Procedure
1.
Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2.
Back up all server data.
3.
Power down the server.
Hardware options installation
112
Advertisement
Table of Contents
